喷淋清洗机具有工位多，功能全，结构合理，操作方便，清洗效果好,对于大批量工件的清洗，改善劳动环境，提高清洗和吹干质量，具有重要的意义。下面来讲讲喷淋清洗机使用方法以及注意相关内容吧。

The spray cleaning machine has many working positions, complete functions, reasonable structure, convenient operation and good cleaning effect. It is of great significance for the cleaning of large quantities of workpieces, improving the working environment and improving the cleaning and drying quality. Let's talk about how to use the spray washer and pay attention to relevant contents.

喷淋清洗机的使用方法：

Usage of spray cleaning machine:

(1)连接电源线。应根据电源的标签进行链接。严禁接错380V和220V。注意：加水前，先检查风机运转是否平稳后再加水。加水后，检查输送带电机和水泵是否接反。如果反了，停机换线。（严禁在未接好接线前打开风扇按钮，否则水会倒流造成风扇损坏）

(1) Connect the power cord. It shall be linked according to the label of the power supply. It is strictly forbidden to connect 380V and 220V incorrectly. Note: before adding water, check whether the fan operates stably before adding water. After adding water, check whether the conveyor belt motor and water pump are connected reversely. If it is reversed, stop the machine and change the line. (it is strictly forbidden to turn on the fan button before the wiring is connected properly, otherwise the water will flow back and cause damage to the fan)

(2)打开主电源开关。主电源开关采用急停开关设计，防止事故发生。可以紧急停止设备。

(2) Turn on the main power switch. The main power switch adopts the design of emergency stop switch to prevent accidents. The equipment can be stopped in an emergency.

(3)启动风扇开关。由于高压气流，打开开关后，风扇可能会发出一定的噪音，不影响设备的使用。

(3) Activate the fan switch. Due to the high-pressure air flow, the fan may make some noise after the switch is turned on, which will not affect the use of the equipment.

(4)启动网带运行开关。（注：启动网带在启动风扇后2-3分钟启动）。

(4) Start the mesh belt running switch. (Note: start the mesh belt 2-3 minutes after starting the fan).

(5)蒸汽源与蒸汽入口相连。

(5) The steam source is connected to the steam inlet.

(6)清洗机两侧有较大的清洗区，清洗方便。

(6) There is a large cleaning area on both sides of the cleaning machine, which is convenient for cleaning.

清洗机由继电器全自动控制。除人工装卸工件外，其余工艺流程均自动完成。

The cleaning machine is fully automatic controlled by the relay. Except for manual loading and unloading of workpieces, other technological processes are completed automatically.

使用喷淋清洗机的注意事项

Precautions for using spray cleaning machine

1、喷淋清洗机使用速度快，运行效果均匀，设备内外槽均采用不锈钢材质。

1. The spray cleaning machine is fast to use and has uniform operation effect. The inner and outer tanks of the equipment are made of stainless steel.

2、喷淋清洗机设备是一种新型连续清洗设备，具有清洗液喷洗、喷水冲洗、风机吹水、热风干燥等功能。

2. The spray cleaning machine is a new type of continuous cleaning equipment, which has the functions of cleaning liquid spray washing, water spray washing, fan blowing, hot air drying and so on.

3、由于设备的工作时间、温度、功率都可以自行调节，对生产效率的提高有很大的帮助，在一定程度上可以节省大量的生产成本。

3. Since the working time, temperature and power of the equipment can be adjusted by themselves, it is very helpful to improve the production efficiency and save a lot of production costs to a certain extent.

4、喷淋清洗机设备在使用过程中，清洗机的储液罐在罐内没有水或溶剂的情况下需要更换。正确的操作和维护工作。

4. During the use of the spray washer equipment, the liquid storage tank of the washer needs to be replaced when there is no water or solvent in the tank. Correct operation and maintenance.

该机器对于大批量工件的清洗是非常不错的选择。不过同样在操作过程中对于一些操作设备该注意的问题还是需要多加了解并注意，才能够更好的操作使用设备。更多相关内容的了解就来我们网站www.jnthcsb.com吧。

This machine is a very good choice for cleaning large quantities of workpieces. However, in the same process of operation, the problems that should be paid attention to for some operating equipment still need to be understood and paid attention to in order to better operate and use the equipment. For more information, please visit our website at www.jnthcsb Com.