通过式清洗机是一种新型的的清洗设备，在工业清洗领域的应用目前十分广泛，下面来讲讲通过式清洗机的操作事项与停机事项。

The through washer is a new type of energy-saving cleaning equipment, which is widely used in the field of industrial cleaning. Now let's talk about the operation and shutdown of the through washer.

操作事项

Operational matters

1工作前先检查清洗液的配方浓度和配方比例是否合适，水箱液面高度是否够。

1 Before working, check whether the formula concentration and proportion of the cleaning solution are appropriate, and whether the liquid level of the water tank is high enough.

2分别调定清洗液箱和漂洗液箱的电接点温度计为50一60度。

2 Set the electric contact thermometer of the cleaning solution tank and the rinsing solution tank to 50-60 degrees respectively.

3用钥匙将电源控制开关，置于开位置。

3 Use the key to turn the power control switch to the ON position.

4开启加热器，使其开始自动加温。

4 Turn on the heater to start automatic heating.

5开启浮油排除装置开始浮油排除，因此式水泵未开启，水面平静，排油效果好。

5 Open the oil slick discharge device to discharge the oil slick, so the water pump is not opened, the water surface is calm, and the oil discharge effect is good.

6等温度升到预定值后即开始工作，操作者根据需要选择开关，按每个单动按钮，使水泵，吸雾，输送等全部动作。

6 When the temperature rises to the preset value, the operation will start. The operator can select the switch as required and press each single action button to make the water pump, fog suction, transportation, etc. all act.

7当机器运行后，操作工人便可以在装料口不断地把零件装载输送网带，清洗，漂洗，吹干，输出，在卸料口取下清洗好的零件。

7 When the machine is running, the operator can continuously load the parts into the conveyor belt at the loading port, wash, rinse, blow dry, and output, and then take down the cleaned parts at the unloading port.

停机事项

Shutdown matters

1清洗工作结束后，当后一个零件取下，按停止按钮，全机停止。

1 After cleaning, when the last part is removed, press the stop button to stop the whole machine.

2清洗液应定期添加自来水和一定比例的金属清洗液以补充消耗，使液面保持在一定高度，如果清洗效果达不到工艺要求时，应全部更换清洗液。

2 The cleaning solution shall be replenished with tap water and a certain proportion of metal cleaning solution regularly to maintain the liquid level at a certain height. If the cleaning effect cannot meet the process requirements, the cleaning solution shall be replaced completely.

3清理设备污垢后，关闭电源。

3 After cleaning the equipment, turn off the power.

此外要记得及时添加清洗剂或更换清洗液、漂洗液。定期检查自来水供应情况，按液位计指示，及时添加满水。等等。更多相关内容事项就来我们网站www.jnthcsb.com进行咨询了解吧！

In addition, remember to add detergent or replace detergent and rinsing solution in time. Regularly check the supply of tap water, and timely add full water as indicated by the level gauge. wait. For more information, please visit our website www.jnthcsb.com!