1.使用温度不得超过40。
1. The operating temperature should not exceed 40.
2.设备周围湿度75%,不能太干。
2. The humidity around the equipment is 75% and should not be too dry.
3.保持清洁室的空气流通。(如果没有空气流通,通风系统每小时2万立方米以上)
3. Maintain air circulation in the clean room. (If there is no air circulation, the ventilation system should be at least 20000 cubic meters per hour)
4.碳氢化合物清洗机设备的排气系统需要与室外连接。(排气系统每小时2200立方米)
4. The exhaust system of the hydrocarbon cleaning machine equipment needs to be connected to the outdoor. (Exhaust system 2200 cubic meters per hour)
5.防爆照明灯应设置在设备布置范围内5.防爆电器。
5. Explosion proof lighting should be set within the equipment layout range. 5. Explosion proof
electrical appliances.
6.设备严禁在阳光下爆炸,以免温度升高,造成安全危险。
6. Explosion of equipment in sunlight is strictly prohibited to avoid temperature rise and safety hazards.
7.严禁在设备周围5米内燃放烟花.引火作业及粉尘。
7. It is strictly prohibited to set off fireworks, ignite operations, and dust within 5 meters of the equipment.
8.用户应直接离设备1(1)直接安装电源(设备电源箱).空气保护开关安装在距离地面1.6米以上的地方。(设备检修时切断电源方便使用)如果有专门的主电源柜,现场必须距离设备5米。
8. Users should install the power supply (equipment power box) directly from the device 1 (1). The air protection switch should be installed at a distance of 1.6 meters or more from the ground. If there is a dedicated main power cabinet, it must be 5 meters away from the equipment on site.
9.冷水机组应设置在清洗设备旁边3-5米之间,并安装排气管装置。(排气量为每小时2万立方米)
9. The chiller should be installed between 3-5 meters next to the cleaning equipment and equipped with an exhaust pipe device. (Exhaust volume is 20000 cubic meters per hour)
使碳氢化合物清洗剂也能实现气相清洗。使用卤代烃清洗剂的工业清洗机利用卤代烃清洗剂的低沸点,在清洗的一步加热清洗剂,使其产生纯净的清洗剂蒸汽,并用溶液蒸汽清洗工件,使溶解在碳氢清洗设备的清洗液中的油污不会留在工件表面。由于碳氢化合物清洗剂的沸点高于闪点,因此在正常压力下不可能清洗工件。真空清洗干燥机利用真空状态下液体沸点降低的原理,通过对密封的清洗罐进行真空大大降低了碳氢化合物溶剂的沸点,只需将碳氢化合物清洗剂加热到80℃左右,可使其沸腾,实现气相清洗。
Enable hydrocarbon cleaning agents to also achieve gas-phase cleaning. The industrial cleaning machine using haloalkane cleaning agent uses the low boiling point of haloalkane cleaning agent to heat the cleaning agent in the first step of cleaning to generate pure detergent steam, and uses solution steam to clean the workpiece, so that the oil stains dissolved in the cleaning solution of hydrocarbon cleaning equipment will not remain on the workpiece surface. Due to the boiling point of hydrocarbon cleaning agents being higher than the flash point, it is impossible to clean the workpiece under normal pressure. The vacuum cleaning and drying machine utilizes the principle of reducing the boiling point of liquids under vacuum, greatly reducing the boiling point of hydrocarbon solvents by vacuuming the sealed cleaning tank. Simply heating the hydrocarbon cleaning agent to around 80 ℃ can make it boil and achieve gas-phase cleaning.
This article is provided by a hydrocarbon cleaning machine for assistance. For more related content, please click on http://www.jnthcsb.com I hope this article can be helpful to you. Thank you for reading!