高压去毛刺清洗机作为一种物理清洗设备，因其是以高压水射流技术为基础的清洗设备，具备无污染、无腐蚀、低成本、率、使用范围广等优势，那么他的正确操作方式是怎样的？

As a kind of physical cleaning equipment, the high-pressure deburring washer is based on high-pressure water jet technology and has the advantages of non pollution, non corrosion, low cost, high efficiency and wide application range. What is its correct operation mode?

1.在使用高压去毛刺清洗机进行清洗工作前，把高压管和设备内的锈及杂质清洗干净。

1. Before using the high-pressure deburring washer for cleaning, clean the rust and impurities in the high-pressure pipe and equipment.

2.须使用清洁的自来水直接从水龙头连接到机器供水处，严格禁止水中出现沙子及其他有害杂质。

2. Clean tap water must be used to connect directly from the tap to the water supply of the machine. Sand and other harmful impurities are strictly prohibited in the water.

3.高压去毛刺清洗机电源应为380V，50HZ，黄/绿线要求接地。

3. The power supply of high-voltage deburring and cleaning machine shall be 380V, 50HZ, and the yellow/green wire shall be grounded.

4.高压去毛刺清洗机燃料尽量使用10#或更高品质的柴油作为燃料，油箱内不能缺油，油内严禁有水分和杂质。

4. 10 # or higher quality diesel oil shall be used as the fuel of high-pressure deburring washer as far as possible. There shall be no lack of oil in the oil tank, and no water and impurities are allowed in the oil.

5.须严格执行正确的开关程序，关时应关闭热水，连续冲洗直到设备完全冷却后，再关闭冷水，才是正确的操作流程。

5. The correct switching procedure must be strictly followed. The correct operation process is to turn off the hot water first, flush continuously until the equipment is completely cooled, and then turn off the cold water.

6.禁止把高压去毛刺清洗机放置于温度低于0摄氏度的环境中，以防止剩余水结冰，影响高压去毛刺清洗机的使用。

6. It is prohibited to place the high-pressure deburring washer in an environment with a temperature lower than 0 ℃ to prevent the remaining water from freezing and affecting the use of the high-pressure deburring washer.

7.须保持水泵中润滑油量，不得少于油窗中心红点的油液面界限。

7. The amount of lubricating oil in the water pump must be kept at least less than the oil level limit of the red dot in the center of the oil window.

8.须遵循柴油滤清器保持及时调换或清洗的流程。

8. The diesel filter must be replaced or cleaned in a timely manner.

9.须遵循时常冲洗进水管中沉积下来的水垢工作。

9. Always wash the scale deposited in the water inlet pipe.

综上所述，是使用高压去毛刺清洗机进行清洗时的正确操作方法，操作者在使用过程中务遵循以上原则，才能使高压去毛刺清洗机发挥出更好的作用。关注我们http://www.jnthcsb.com，了解更多！

To sum up, it is the correct operation method when using the high-pressure deburring cleaning machine for cleaning. The operator must follow the above principles in the use process to make the high-pressure deburring cleaning machine play a better role. Follow us http://www.jnthcsb.com , learn more!